Wooden Half - Finished Product For Masts

By Artem Popov

How the wooden sticks of any diameter can be produced? It is possible easily and quickly to produce at the help usual disks used for treading of screws. (It seems they are called "tap and die sets") The half - finished piece of wood clutches in a drill machine, and to pass through the disk of suitable of the size. The operation is repeating, but already with a disk of a smaller diameter. So do until the mast will not reach a necessary diameter. Final processing is done with the help of the sandpaper, not taking out the mast from drill machine.

You can provide the disks from 1,5 mm to 5,0 mm with a step - 0,5 mm. It is speed up your works by making a masts, yards, and other details.

Table of contents:

• Ships in bottles. How to put a ship into a bottle?
• Method 1. Traditional.
• Method 2. Straws
• Method 3. Without a joint
• Method 4. A Joke?
• Method 5. Great potential
• Instruments
• Handy hints and tips for boat model makers
• Incredible Corks
• Unusual ship models in bottles.
• Stands, drawing and bottles